CNC Electric · YCM1
Product overview
The YCM1-250L is a thermal-magnetic moulded case circuit breaker for power distribution. The 250A frame provides overload and short-circuit protection with the L breaking-capacity class. This page covers the direct-handle, three-pole distribution versions.
Technical selection summary
| Brand | CNC Electric |
|---|---|
| Model / frame | YCM1-250L / 250A frame |
| Poles | 3P |
| Rated currents | 100, 125, 140, 160, 180, 200, 225, 250A |
| Frequency | AC50Hz |
| Rated insulation voltage Ui | 800V |
| Rated impulse withstand Uimp | 8kV |
| Icu | 35kA at AC230V; 35kA at AC400V; 8kA at AC690V |
| Ics | 22kA at AC230V; 18kA at AC400V; 4kA at AC690V, catalogue table |
| Release / operation | Thermal-magnetic release; direct manual handle |
| Standard listed | IEC60947-2 |
| Endurance | Electrical 3000 operations; mechanical 20,000 operations |
| Dimensions | W107×L165×H86mm; mounting centres 70×126mm; fixing holes Ø5mm |
| Installation | Vertical or horizontal; fixed mounting |
| Operating conditions | −5 to +40°C, 24h average ≤35°C; altitude ≤2000m; pollution degree3 |
Selection and installation
The original photograph shows a YCM1-250L/3300 225A unit within the selectable current range. The live nameplate states Icu/Ics 35/22kA at 400V, while the supplied family catalogue lists 35/18kA at 400V for the L table column. This page uses the lower catalogue Ics for selection; verify the supplied nameplate when a project requires a specified service breaking capacity. The 35kA Icu at 400V is consistent. Motor-drive, rotary-handle, internal-release accessories and four-pole products are separate configurations and are not included by default.
Typical applications
Low-voltage distribution feeders; industrial power-distribution panels; overload and short-circuit protection of compatible circuits.
Original technical data and drawings
The following manufacturer figures retain the original technical content. Dimensions are in millimetres unless otherwise marked. Refer to the model and frame labels when using a shared family drawing.








