Product overview
100 A automatic/manual AC phase selector with three L/N inputs, one L/N output, adjustable phase priority, voltage and current protection, and an audible alarm.

Technical specifications
| Model | TOAPSVP2-100A |
|---|---|
| Rated supply | 220 V AC per L/N input |
| Operating voltage | 140–300 V AC |
| Frequency | 50/60 Hz |
| Current | 100 A nameplate rating |
| Inputs and output | 3 L/N inputs; 1 L/N load output |
| Protection | Overvoltage, undervoltage and overcurrent |
| Voltage hysteresis | 5 V, overvoltage and undervoltage |
| Voltage accuracy | ≤1% over operating range |
| Insulation voltage | 450 V |
| Enclosure | IP20; pollution degree 3 |
| Operating temperature | −5 to +40 °C |
| Humidity / altitude | ≤50% RH at 40 °C; ≤2,000 m |
| Storage temperature | −25 to +55 °C |
| Electrical / mechanical life | 100,000 operations each |
Phase selection and protection
Set the input priority to ABC, ACB, BAC, BCA, CAB or CBA. The selector monitors three 220 V AC line-to-neutral inputs and transfers the single-phase load according to the priority and protection settings. Three front switches allow the individual inputs to be switched off. The display shows each input voltage and output current.
Timing and alarm
The menu provides a 1–600 s power-on delay, adjustable priority detection and recovery timing, a 0.1–30 s overcurrent action delay and an optional repeated-fault lockout. The audible alarm can be disabled.
Terminals and installation
The product diagram identifies the three L/N input pairs, L/N load output, and separate NC/COM/NO signal terminals. Use the exact product terminal markings and install in a suitable enclosure. Refer to the settings chart and original wiring drawing before installation.
















